Filter By
Brand
Brand
If you are looking for a glove suited to mainsheet trimming; where releasing the sheet is just as important as pulling in, the Dura Pro may be the answer. With double layer top quality abrasion resistant Amara on all high load/stress areas, these gloves are extremely supple with excellent grip and are perfect for all helming duties.
The Rooster Pro Lite Aquafleece top combines a soft, durable and flexible polyurethane outer coating with a light fleece inner layer to keep you snug and warm.
Rooster's low profile neoprene buoyancy aid, ideal for dinghy racing.
Rooster's Polilite rope, ideal for Laser/ILCA. 14 meters in length, 7 mm diameter
Keep hydrated and limit single use plastic with our bottle! Suitable for any occasion, our durable 710ml capacity drinks bottle has an ergonomic nozzle for easy drinking and increased water flow.
Perfectly suited to be used with Rooster's Joey Bottle Holder.
If you are looking for a glove suited to mainsheet trimming; where releasing the sheet is just as important as pulling in, the Dura Pro may be the answer. With double layer top quality abrasion resistant Amara on all high load/stress areas, these gloves are extremely supple with excellent grip and are perfect for all helming duties.
Rooster's Polilite rope, ideal for Laser/ILCA. 14 meters in length.
Low bulk, lightweight performance Rooster spray top perfect for those wet windy moderate to hot days where you don’t need the warmth of the Aquafleece® but want a bit more protection from the elements. This breathable and waterproof top packs up small enough to easily stuff into your 10L drybag for easy storage.
Rooster toestraps use a unique rubber compound that has a very high coefficient of friction, whilst also being light and durable.
Rooster's 50mm clew strap suitable for Laser/ILCA.
These bailer spring plates are manufactured using the highest quality spring stainless steel, designed to both retract using spring tension, and at the same time providing a surface for the activator to push against to close the chute.
Laser Mast Wear Kit contains two stripes of UHMWPE with acrylic adhesive on liner to be applied on the mast boot and mast collar complete to reduce the wear and tear of the gelcoat.
Two stripes of 21 mm of width and 200 mm in length.
Official batten set for ILCA 4 and ILCA 6. Also suitable for Laser 4.7 and Laser Radial.
Official carbon lower mast section for ILCA 6
Official batten set for ILCA 7. Also suitable for Laser Standard
A pack of three green and three red self adhesive wool telltales (with TEFLON treatment) that don´t stick to the sail in the wet.
Rooster Sailing self adhesive grip tape for use on your deck.
Moulds to fit the surface applied to providing a strong connection and durable grip. When you want to remove it, it's easy and clean and does not leave any residue when peeled off.
Available in a number of colours.
Rooster's Polilite rope, ideal for mainsheet applications on racing dinghies.
Neoprene sleeve bottle holder with adjustable webbing straps at each end to fit around different circumferences of tube.
Spinlock XAS0612/2 double clutch for 6 to 12 mm ropes.
Rooster Sailing's all purpose boot, suitable for al water sports.
Waxed whipping twine, useful for finishing the ends of rope or for adding a stitch to the join in spliced ropes.
0.8mm diameter with approx. 50m on a roll - priced per roll.