A one-liter (approximately 750 g) tin of grey gelcoat, specially formulated for repairing your DevotiKDK Boat. Also suitable for use on other boats.
Please note:
We do not sell the MEK peroxide catalyst, and it will need to be purchased locally to properly cure the gelcoat.
Available for purchase only in the Spanish and Portuguese mainland. Excludes the Canary Islands, Balearic Islands, the Azores, Madeira, Ceuta, and Melilla due to Dangerous Goods carriage restrictions.
This product should be used within two months of purchase.
A one-liter (approximately 750 g) tin of white gelcoat, specially formulated for repairing your KDK and DevotiKDK Boat. Also suitable for use on other boats.
Please note:
We do not sell the MEK peroxide catalyst, and it will need to be purchased locally to properly cure the gelcoat.
Available for purchase only in the Spanish and Portuguese mainland. Excludes the Canary Islands, Balearic Islands, the Azores, Madeira, Ceuta, and Melilla due to Dangerous Goods carriage restrictions.
This product should be used within two months of purchase.
A one-liter (approximately 750 g) tin of pre-accelerated, thixtropic isophthalic polyester resin. Suitable for hand lamination.
Please note:
We do not sell the MEK peroxide catalyst, and it will need to be purchased locally to properly cure the gelcoat.
Available for purchase only in the Spanish and Portuguese mainland. Excludes the Canary Islands, Balearic Islands, the Azores, Madeira, Ceuta, and Melilla due to Dangerous Goods carriage restrictions.
This product should be used within two months of purchase.
Laser Mast Wear Kit contains two stripes of UHMWPE with acrylic adhesive on liner to be applied on the mast boot and mast collar complete to reduce the wear and tear of the gelcoat.
Two stripes of 21 mm of width and 200 mm in length.
This Laser vang unit offers ultimate control over your vang control line. The cam cleat is mounted to a swivel, this ensures you can pull the vang control line from any angle and with minimal friction.
The block formation of our Laser / ILCA vang unit ensures the vang control line does not twist under load.
Easily attached to the Laser / ILCA mast tang with a nut and bolt.
Also featured is a removable clevis pin which can be used to dead-end the Cunningham control line.
Laser/ ILCA control line cam cleats with angled base, Pro-lead and wire under-fairleads.
The base has been optimised with a small angle to ensure the control lines can easily be adjusted when hiking and the Pro-lead ensures the rope guides easily into the mouth of the cam cleat from any angle.