If you are looking for a glove suited to mainsheet trimming; where releasing the sheet is just as important as pulling in, the Dura Pro may be the answer. With double layer top quality abrasion resistant Amara on all high load/stress areas, these gloves are extremely supple with excellent grip and are perfect for all helming duties.
These bailer spring plates are manufactured using the highest quality spring stainless steel, designed to both retract using spring tension, and at the same time providing a surface for the activator to push against to close the chute.
Laser Mast Wear Kit contains two stripes of UHMWPE with acrylic adhesive on liner to be applied on the mast boot and mast collar complete to reduce the wear and tear of the gelcoat.
Two stripes of 21 mm of width and 200 mm in length.
Rooster Sailing self adhesive grip tape for use on your deck.
Moulds to fit the surface applied to providing a strong connection and durable grip. When you want to remove it, it's easy and clean and does not leave any residue when peeled off.
This Laser vang unit offers ultimate control over your vang control line. The cam cleat is mounted to a swivel, this ensures you can pull the vang control line from any angle and with minimal friction.
The block formation of our Laser / ILCA vang unit ensures the vang control line does not twist under load.
Easily attached to the Laser / ILCA mast tang with a nut and bolt.
Also featured is a removable clevis pin which can be used to dead-end the Cunningham control line.
Laser/ ILCA control line cam cleats with angled base, Pro-lead and wire under-fairleads.
The base has been optimised with a small angle to ensure the control lines can easily be adjusted when hiking and the Pro-lead ensures the rope guides easily into the mouth of the cam cleat from any angle.